Removing Lincoln Town Car Front Door Speakers
Lincoln Town Car How to Remove Front Speaker 1.1) Remove screws or panel pins from leading edge of door panel. 2.1) Remove caps at both sides of door handle and remove exposed screws. 3.1) Open pocket and remove exposed screws. 4.1) Gently pry leading edge of control panel, pull forward releasing back latch. 5.1) Remove hidden screw through small panel opening. (We might have missed a step here with the panel around the door open handle and door lock switch?) 6.1) Gently pull door panel from door starting at bottom, lift panel up and out of window sill. 6.2) Disconnect all connectors from door panel. 7.1) Remove screws securing speaker to door, disconnect connector.
Lincoln Town Car '95-97 Car Stereo Removal and Installation Lincoln Town Car '95-97 Stereo Removal and Installation "Din Tools" Din Tools can be purchased at a local Auto Parts Store. They are Ford Car Stereo removal tools. 1) Insert "Din tools" into holes on both sides of radio. 2) Push tools slightly to the outside of the car stereo, this releases the lock mechanism, pushing them to the side of the car stereo. 3) Pull unit forward from dash. 4) Remove antenna and connectors.
Lincoln Town Car '95-97 How to Remove and Install Rear Speaker Instruction 1) Remove bottom cushion from car. 1) Remove screws from side of rear center brake light. 1) Remove rear center brake light and disconnect connector. 1) Remove bolt from along bottom of rear seat back cushion. 2) Lift rear seat up releasing hooks. 3) Lift rear deck panel releasing clips.
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up
	NO AUDIO With aftermarket stereo installation?
	Erratic Volume Control DIY Repair
Lioncoln Power Antenna Mast Replacement These instructions work only if your the power antenna motor runs when the car stereo is turned on and off. Purchase a new mast from the dealership. Lincoln Power Antenna Mast Removal and Installation Instructions 1) With needle nose pliers, insert nose into slots on nut at top of antenna base. 1) Remove nut and base from antenna mast. 2) Turn car stereo on, remove antenna mast and nylon cable by pulling from power motor assembly. *NOTE - Measure length of new antenna mast against old antenna mast. (In this picture, there is no nylon cable attached to mast). If they match in length, insert new mast and turn stereo off. Feed nylon cable into motor. Install mast base and nut. If they do not match in length continue with instructions. Turn car stereo on/off for testing. 1) Remove two plastic side panel tabs from panel. 1) Pull side panel from car, feeding manual gas flap release through panel. 1) Disconnect antenna cable and connectors from power antenna assembly. 2) Remove bolts securing power antenna motor assembly. 1) Place antenna motor assembly on flat ground for disassembly. 1) Remove cover from power antenna motor assembly. 1) Remove gear assembly. 2) Remove nylon cable from cover. 3) Inspect power assembly for debris and pieces of nylon cable. 4) Reassemble and assembly into car. 5) Turn car stereo one, allow power antenna to cycle, feed nylon cable into antenna and turn car stereo off. 6) Install antenna base and nut.
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You