Car Radio Repair - Car Radio Removal - Replace and Install Car Stereo

Suzuki Grand Vitara, Vitara and XL7 Car Audio

Suzuki
Car Stereo Removal

Suzuki
Aftermarket Car Stereo Install

Factory Wire Harness, Color Codes and Aftermarket Installation

Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up

NO AUDIO
With aftermarket stereo installation?

Erratic Volume Control
DIY Repair

Suzuki Front Door Panel Speaker Removal
	How to Remove and Install Suzuki Rear Door Panel Speaker
	1.1) ROLL WINDOW DOWN! 1.2) Gently pull top panel from door.
	2.1) Release clips to remove panel and set to side.
	3.1) Remove one screw in door open handle trim panel.
	4.1) Push trim panel toward front of door panel to release securing hooks.
	5.1) Pull trim panel from opening and allow to hang in place for now.
	6.1) Remove one screw from hand hold on arm rest.
	7.1) Starting at bottom of door panel, pull away from door releasing clips. 7.2) Work your way up front and rear edges of door panel releasing all clips.
	8.1) Lift back of door panel up out of window jam and over door lock. Be sure door lock pin lines up with opening when reinstalling.
	9.1) Lift front edge of door panel up out of window jam. 9.2) Feed door open handle and trim through door panel opening.
	10.1) From opposite side of door, hold door panel for access to connectors at control panel.
	11.1) Release triggers on connectors to disconnect and set door panel to side.
	12.1) Remove screws securing speaker to door. NOTE - for determining aftermarket installation polarity of speaker wires for correct hook up see Speaker Phasing above.
	13.1) Check door for door panel clips that remained.
	14.1) Gently pry panel pin from door.
	15.1) Place panel pin back onto door panel before reinstallation.

Suzuki Rear Door Panel Speaker Removal and Installation
	How to Remove and Replace Suzuki Front Door Panel Speaker
	1.1) Remove one screw in door open handle trim panel.
	2.1) Push trim panel toward front of door panel to release securing hooks.
	3.1) Pull trim panel from opening and allow to hang in place for now.
	4.1) Remove one screw from hand hold on arm rest.
	5.1) Starting at bottom of door panel, pull away from door releasing clips.
	6.1) Work your way up front and rear edges of door panel releasing all clips.
	7.1) Lift back of door panel up out of window jam.
	8.1) Lift front edge of door panel up out of window jam and up over door lock pin. Be sure door lock pin lines up with opening when reinstalling.
	9.1) Lift front edge of door panel up out of window jam. 9.2) Feed door open handle and trim through door panel opening.
	10.1) From opposite side of door, hold door panel for access to connector at control panel.
	11.1) Release triggers on connectors to disconnect and set door panel to side.
	12.1) Check door for door panel clips that remained.
	13.1) Gently pry panel pin from door.
	14.1) Place panel pin back onto door panel before reinstallation.
	15.1) Remove screws securing speaker to door. NOTE - for determining aftermarket installation polarity of speaker wires for correct hook up see Speaker Phasing above.