Chevrolet Impala Car Stereo Removal and Installation
Chevrolet Impala How to Remove and Install Car Stereo 1.1) Open glove box. This will allow the front panels lip to have clearance when removing front panel in a later step. 2.1) Remove one screw along bottom edge of dash on passenger side of car near center console. 3.1) Remove one screw along bottom edge of dash on driver's side of car near center console. 4.1) Remove next screw along bottom edge of dash on driver's side. 5.1) Remove one more screw along bottom edge of dash on driver's side. 6.1) Remove cover panel from fuse panel. 7.1) Remove one exposed screw from fuse panel cover removal. 8.1) Set steering column to lowest position. 8.2) Remove two screws along top of panel above gauges. 9.1) Lift panel up that goes around gauges. 10.1) Remove panel from gauges and lift from above steering column. 11.1) Pull remaining dash panel from front dash next to steering column. 12.1) With glove box open, pull entire front panel from dash releasing all clips. 13.1) Dash panel will now set down and rest on floor of car. 14.1) Remove three screws securing car stereo to dash. 15.1) Pull car stereo forward from dash. 16.1) Remove antenna connector and release trigger on main connector. 16.2) Remove car stereo.
	Factory Wire Color Codes See Diagrams Below
	Aftermarket Wire Color Codes See Diagrams Below
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up Speaker Phasing Font Left   Front Right + Tan   + Light green - Gray   - Dark green       Rear Left   Rear Right + Brown   + Dark blue - Yellow   - Light blue
	NO AUDIO With aftermarket stereo installation?
	Erratic Volume Control DIY Repair
Wire Diagrams, Cadillac, Chevrolet, Corvette, Geo, GMC, Oldsmobile, Pontiac and Saturn. DO NOT CUT FACTORY WIRE HARNESS     Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above. We discourage cutting the factory wire harness. This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons. Diagrams may not be applicable to Bose Audio Systems     1988 - 2005 IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. 1   Gray Left Front Speaker (-) 2   Tan Left Front Speaker (+) 3   Dark Green Right Front Speaker (-) 4   Light Green Right Front Speaker (+) 5   Black Ground 6   Brown Illumination 7   Gray Dimmer 8   Blank   9   Yellow* (Green) Switched +12 volts 10   Orange Constant +12 volts 11   Light Blue Right Rear Speaker (-) 12   Dark Blue Right Rear Speaker (+) 13   Yellow Left Rear Speaker (-) 14   Brown Left Rear Speaker (+)     All wire diagrams and color codes are not 100% accurate.
Front and Rear Speaker Removal and Replacement presently not available.
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You