Car Radio Repair - Car Radio Removal - Replace and Install Car Stereo

Dodge Ram 1500 Car Stereo, Front Door Speaker Removal

	Dodge Ram 1500 How to Remove and Install Car Stereo Instructions
	1.1) Pull cup holder out and remove two screws at each side of cup holder mounting bracket. 1.2) Remove cup holder assembly.
	2.1) Pull ash tray out and remove two screws securing ash tray holder assembly. 2.2) Remove ash tray holder assembly.
	3.1) Apply parking brake, turn ignition to on position and place gear shift in lowest position. 3.2) Pull trim panel across dash off, releasing clips. 3.3) Remove cig lighter and aux. 12 volt supply connectors. 3.4) Remove two 10mm bolts securing stereo to dash disconnecting all wires.

Aftermarket Car Stereo Install and Help

Afermarket
Car Stereo Installation

Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up

NO AUDIO
With aftermarket stereo installation

Dodge Ram Front Door Panel / Speaker Removal
	Dodge Ram How to Remove and Install Front Door Panel / Speaker Instructions
	1.1) Remove two screws from door handle pull cavity. 1.2) Remove cavity from door panel.
	2.1) Remove one screw from top leading edge of door panel.
	3.1) Pry front edge of control panel from door. Pull forward releasing back clip.
	4.1) Pull door panel from door by releasing 13 clips by starting at bottom of panel. 4.2) Lift panel up out of window jam and over door lock while feeding control panel and door open handle through door panel.
	5.1) Remove four screws securing 5" X 7" speaker to door. 5.2) Pull speaker from door panel and release connector.