Removing Honda Ridgeline Car Stereo and Speakers
	Honda Ridgeline Car Stereo Removal
	Honda Ridgeline Wire Color Codes
	Aftermarket Car Stereo Wire Color Codes and Hook Up
	Radio CodE
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up
	NO AUDIO With aftermarket radio installation?
	DIY Repair Erratic Volume Control
DIY Honda Ridgeline Front Speaker Remove and Install DIY Honda Ridgeline Front Speaker Removal 1.1) Pry top edge of small triangular panel at top front edge of door panel releasing clip. All clips release with pry pressure.  2.1) Pull to edge of small triangular panel back from door. 3.1) Lift small triangular panel up to release bottom of panel, remove and set to side. 4.1) Pry bottom of insert panel at door handle cavity to release. 5.1) Remove panel and set to side. 6.1) Remove exposed lower 7 mm screws from cavity. 7.1) Remove exposed upper 7 mm screws from cavity. 8.1) Pull door handle assembly from door panel. 9.1) Locate door handle cable linkage. 10.1) Lift bass up to release cable linkage. 11.1) Locate lock at end of cable. 12.1) Swing lock to side to release from end of cable. 13.1) Lift end of cable from socket to remove. 14.1) Remove door handle assembly and set to side. 15.1) Remove three exposed screws from door handle cavity. 16.1) Remove insert panel at bottom of hand hold on door panel and set to side. 17.1) Remove exposed screw from hand hold cavity. 18.1) Pry back bottom edge of door panel from door releasing clips. 19.1) Pry along bottom of door panel, pry up front and back edges of door panel releasing all clips. 20.1) Pull bottom edge of door panel away from door verifying all clips have been released. 21.1) Lift back edge of door panel up out of window jam and over door lock to release. 22.1) Lift front edge of door panel up our of window jam, pull top edge of door panel back for access to connectors. 23.1) Squeeze trigger along edge of connector into connector to release and remove connector. 24.1) Along bottom of control panel, into release trigger on connector and disconnect. 25.1) Along bottom of control panel, into release trigger on connector and disconnect. 26.1) Along bottom of control panel, into release trigger on connector and disconnect, remove door panel and set to side. 27.1) Check door for any remaining door panel clips. 28.1) Pry door panel clips from door to remove. 29.1) Place end of door panel clip into corresponding slot on door panel ready for reinstallation. 30.1) Push down at top edge of speaker to release clip while prying top of speaker away from door to release. 31.1) Grasp top edge of speaker assembly and pull up to release bottom of speaker from door, release connector to disconnect. 32.1) When reinstalling door handle assembly, both clips snap into place to secure.
Rear Speaker Removal and Replacement Presently Not Available
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You