Car Radio Repair - Car Radio Removal - Replace and Install Car Stereo

Removing and Installing Stereos and Speakers Mercury Sable

Car Stereo Removal

Wire Color Codes and Hook Up

Aftermarket
Wire Color Codes and Hook Up

Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up

NO AUDIO
With aftermarket stereo installation?

Erratic Volume Control
DIY Repair

Mercury Sable Front Speaker Removal and Install
	How to Remove and Install Speakers
	1.1) Remove one screw for arm rest hand hold pocket.
	2.1) Remove two screws along back edge of door panel.
	3.1) Gently pry insert at door open handle.
	4.1) Remove insert and one exposed screw.
	5.1) Remove one screw along leading edge of door panel.
	6.1) Gently pull door panel from door releasing clips. 6.2) Lift door panel up out of window jam.
	7.1) Pull top edge of door panel down for access to back of panel.
	8.1) Release triggers on connectors at control panel and remove door panel.
	9.1) Remove four screws securing factory 5 x 7 inch car speaker.
	10.1) Check door for remaining door panel clips. 10.2) Pry clips from door.
	11.1) Insert clips back onto door panel before reinstallation.

Mercury Sable CD Changer Removal
	1) Open center console. 2) Gently pry plastic trim panel from console pocket.
	1) Remove trim panel and set to side.
	1) Remove four screws securing CD changer to center console.
	1) Remove CD changer from pocket. 2) Release trigger on connector to disconnect.

Car stereo and speaker removal presently not available, bring it by.