Car Radio Repair - Car Radio Removal - Replace and Install Car Stereo

Mitsubishi Outlander Car Stereo Removal and Replacement

	Mitsubishi Outlander How to Remove and Install Car Stereo
	AC Control Cables 1.1) Under dash on driver's side of car along side of center console are controls for your AC. 1.2) With pliers, squeeze small peg to allow ring at end of cable to release over peg.
	2.1) Push securing metal clip apart to release cable.
	3.1) Removed AC control cable. Lower cable is white.
	4.1) Repeat process for upper AC cable. This cable is blue.
	5.1) Both AC control cables released.
	6.1) Gently pry lower edge of car stereo trim panel from dash.
	7.1) Work your way up side of dash and repeat for right side of trim panel.
	8.1) Pull car stereo trim panel forward from dash.
	9.1) Reach behind panel, release triggers on two connectors to disconnect. 9.2) Remove trim panel and AC control cables will follow.
	10.1) Remove four screws securing car stereo and mounting brackets to dash.
	11.1) Pull car stereo from dash, remove antenna and release trigger on connector to disconnect.

Aftermarket Car Stereo
Wire Harness

Factory Wire Harness Codes
Below

Factory Wire Harness, Color Codes and Aftermarket Installation

Factory Wire Harness Codes
Below

Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up

NO AUDIO
With aftermarket stereo installation?

Erratic Volume Control
DIY Repair

Front and Rear Speaker Removal presently not available.

Factory Wire Harness Codes

DO NOT CUT FACTORY WIRE HARNESS

Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above.

We discourage cutting the factory wire harness.

This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons.

Diagram 1